See my article about Network configuration for FTP passive mode for details. Error: Failed to retrieve directory listing FileZilla Server (000037) 13:11:57 PM - (not logged in) (96.240.36.82)> Connected, sending welcome message. If that's the case, most usual problem is that some firewall (or the NAT) on the way between you and the server blocks the connection attempt to the data port (as reported in the response to the PASV command). Error: The data connection could not be established: ECONNREFUSED - Connection refused by server Response: 425 Can't open data connection. ![]() Though as you mention that "Browsing is nearly impossible", it looks like that it does not help. Response: 220 FZ router and firewall tester ready. This is the message I get from the network configuration wizard: Connecting to. So in most cases, you won't notice the problem at all. Status: Connection attempt failed with 'ECONNREFUSED - Connection refused by server'. When encountering this, FileZilla tries to connect to the primary address of the FTP server instead, as that is usually the correct address to use. You should see the offending address in the FileZilla log: It's quite common though that the FTP server is behind a NAT. ![]() The client should connect to that IP/port to initiate the transfer. The server responds with its IP address and port number. FileZilla does too and reports the mentioned message. To establish a data connection for a file transfer or a directory listing, an FTP client (in the passive FTP mode) sends PASV command to the server. There can be a few main reasons that cause ECONNREFUSED Connection refused by a server in FileZilla FTP client. The FTP server must report its external IP address, that can be used outside the NATted networks.Īs this is unfortunately a common issue, many FTP clients try to detect this (by checking that the reported IP address is within the range of addresses reserved for local communications within a private network). It's clearly a misconfiguration of the FTP server. ![]() When it reports such IP address to a client outside the NAT, the IP address is obviously of little use. And it's aware of its local address within its NATted network only. To establish a data connection for a file transfer or a directory listing, an FTP client (in the passive FTP mode) sends PASV command to the server.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |